riedon inc. 300 cypress avenue alhambra ca 91801 (626) 284-9901 (626) 284-1704 www.riedon.com type 0805 1206 1210 2010 2512 4020 power rating - p 70 ( w @ 70c) 0.125 0.25 0.35 0.5 1.0 1.5 working voltage ( vac ) trimmed 200 600 800 1500 2000 4000 untrimmed (> 5%) 400 1000 1200 2000 3000 6000 resistance range ( w ) tolerances available ( % ) temperature coeffcients available ( ppm/c ) voltage coeffcients available ( ppm / v ) 100k - 100m 0.5% to 10% 25 / 50 / 100 100ppm/v 0.5% to 10% 25 / 50 / 100 50ppm/v 0.5% to 10% 25 / 50 / 100 50ppm/v 0.5% to 10% 25 / 50 / 100 25ppm/v 0.5% to 10% 25 / 50 / 100 10ppm/v 0.25% to 10% 25 / 50 / 100 5ppm/v >100m - 1g 2% to 20% 50 / 100 / 250 250ppm/v 2% to 20% 50 / 100 / 250 100ppm/v 1% to 20% 25 / 50 / 100 50ppm/v 1% to 20% 25 / 50 / 100 50ppm/v 1% to 20% 25 / 50 / 100 25ppm/v 0.5% to 20% 25 / 50 / 100 10ppm/v >1g - 10g 5% to 20% 250 / 500 500ppm/v 5% to 20% 50 / 100 / 250 250ppm/v 2% to 20% 25 / 50 / 100 100ppm/v 2% to 20% 25 / 50 / 100 100ppm/v 2% to 20% 25 / 50 / 100 50ppm/v 1% to 20% 25 / 50 / 100 10ppm/v >10g - 100g 10% to 30% 2000 2000ppm/v 10% to 30% 250 / 500 / 1000 1000ppm/v 5% to 30% 250 / 500 / 1000 500ppm/v 5% to 30% 100 / 250 / 500 500ppm/v 5% to 30% 100 / 250 / 500 100ppm/v 2% to 30% 100 / 250 / 500 50ppm/v >100g - 1t 20% to 30% 3000 5000ppm/v 10% to 30% 1000 / 2000 2000ppm/v 5% to 30% 1000 / 2000 1000ppm/v 5% to 30% 500 / 1000 1000ppm/v 5% to 30% 250 / 500 500ppm/v 5% to 30% 250 / 500 250ppm/v >1t - 10t - 20% to 30% tcr / vcr on request 20% to 30% tcr / vcr on request 20% to 30% tcr / vcr on request 10% to 30% tcr / vcr on request 10% to 30% tcr / vcr on request hvs series ? resistances from 100k to 10t ohms ? power rating 0.125 to 1.5 watt ? resistance tolerances to 0.25% ? tcrs to 25 ppm/c ? non-magnetic (contact ptag) ? high value thick film resistance element ? sizes: 0805 / 1206 / 1210 / 2010 / 2512 / 4020 ? special ht version to 300c specifications high voltage / high temperature thick film chip resistors 1) solder pads must have suffcient heat conduction 2) tcr in ppm/k; +25c to +125c; tcr below standard tcr (highest value) and values >100g; +25c to +85c 3) vcr: typical values, all negative, not for all tcr values available 09/13
riedon inc. 300 cypress avenue alhambra ca 91801 (626) 284-9901 (626) 284-1704 www.riedon.com specifcation value temperature range -55c to +155c (standard) -55c to +300c (ht version, tcr valid +25c to +125c ) climactic cetegory 55 / 155 / 56 solderability 250c / 3s (up to 6 month after shipment resp. at storage in nitrogen) max. soldering temperature 260c / 10s long term stability max dr <1 gw 1 gw - 10 gw >10 gw load life 70c / 1000h / p 70 0.25% 0.5% 1% storage 125c / 1000h 0.5% 1% 2% maximum voltage / 1000h 0.5% 1% 2% packaging: bulk or tape & reel per iec 286-3 / eia 481-1-a tape width 8mm / reel diameter 180 or 330mm minimum quantity bulk / 100 pieces per value minimum quantity tape & reel / 500 pieces per value hvs series high voltage / high temperature thick film chip resistors type dimensions l b d c hvs 0805 0.080 +0.006 / -0.002 [ 2.0 +0.15 / -0.05 ] 0.050 +0.006 / -0.002 [ 1.25 +0.15 / -0.05 ] 0.016 +0.006 / -0.002 [ 0.4 +0.15 / -0.05 ] 0.012 +0.008 / -0.004 [ 0.3 +0.2 / -0.1 ] hvs 1206 0.126 +0.006 / -0.002 [ 3.2 +0.15 / -0.05 ] 0.060 +0.008 / -0.002 [ 1.5 +0.2 / -0.05 ] 0.016 +0.006 / -0.002 [ 0.4 +0.15 / -0.05 ] 0.012 +0.008 / -0.004 [ 0.3 +0.2 / -0.1 ] hvs 1210 0.126 +0.006 / -0.002 [ 3.2 +0.15 / -0.05 ] 0.098 +0.008 / -0.002 [ 2.5 +0.2 / -0.05 ] 0.020 +0.006 / -0.002 [ 0.5 +0.15 / -0.05 ] 0.032 0.008 [ 0.8 0.2 ] hvs 2010 0.20 +0.008 / -0.002 [5.1 +0.2 / -0.05 ] 0.098 +0.008 / -0.002 [ 2.5 +0.2 / -0.05 ] 0.024 +0.006 / -0.002 [ 0.6 +0.15 / -0.05 ] 0.05 0.008 [ 1.2 0.2 ] hvs 2512 0.250 +0.006 / -0.002 [ 6.3 +0.15 / -0.05 ] 0.138 +0.008 / -0.002 [ 3.5 +0.2 / -0.05 ] 0.024 +0.006 / -0.002 [ 0.6 +0.15 / -0.05 ] 0.035 0.008 [ 0.9 0.2 ] hvs 4020 0.40 +0.006 / -0.002 [ 10.20 +0.15 / -0.05 ] 0.20 +0.008 / -0.002 [ 5.1 +0.2 / -0.05 ] 0.024 +0.006 / -0.002 [ 0.6 +0.15 / -0.05 ] 0.035 0.008 [ 0.9 0.2 ] ordering information part description: part type - resistance - tolerance - tcr example: hvs 2512 10g 10% 50ppm (note: if no tcr is specifed, highest value will be supplied) 0 50 100 150 200 250 300 350 0 20 40 60 80 100 120 power ( % ) ambient temperature (c) power derating curve ht version standard 09/13
|